CDBGN - THREAD LOCKER/BEARING MT

  • MSDS: CDBGN
  • Manufacturer: X ERGON DIV OF NCH CORP
  • Product Name: THREAD LOCKER/BEARING MT
  • National Stock Number: 6850-00F052230
Product Identification

Product ID:THREAD LOCKER/BEARING MT
MSDS Date:01/14/1992
FSC:6850
NIIN:00F052230
MSDS Number: CDBGN

Responsible Party
X-ERGON DIV OF NCH CORP
1400 E NORTHGATE DR
IRVING, TX 75015-2102
US

Emergency Phone: 214-438-1381/800-442-7950

Info Phone: 800-442-7950/214-438-1381

Cage: 55649

Contractor
X-ERGON A PARTSMASTERS CO DIV NCH CORP
152170 IRVING, TX 75015 US

Telephone: 972-438-1381

Cage: 55649

Ingredients

ACRYLIC COPOLYMER *96-4*

CAS: 25608-33-7


CUMENE HYDROPEROXIDE

CAS: 80-15-9

RTECS: MX2450000

EPA Report Quantity: 10 LBS

DOT Report Quantity: 10 LBS


TRIETHYLENE GLYCOL DIMETHACRYLATE

CAS: 109-16-0

RTECS: OZ4100000

Hazards

Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: IRRITATION. SKIN: IRRITATION,
DERMATITIS.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION

First Aid

First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: FLUSH W/WATER FOR 15
MINS. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Fire Fighting

Flash Point Method:TCC
Flash Point:>200F
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR APPROPRIATE RESPIRATORY PROTECTION.
Unusual Fire/Explosion Hazard:ACRID FUMES IF HEATED

Accidental Release

Spill Release Procedures:SOAK UP IN INERT ABSORBENT/W/RAGS. IF AMOUNT
IS SMALL STORE IN A CLOSED CONTAINER UNTIL DISPOSAL.

Handling

Handling and Storage Precautions:STORE AT MODERATE TEMPS. KEEP OUT OF
REACH OF CHILDREN.

Exposure Controls

Ventilation:LOCAL: RECOMMENDED.
Protective Gloves:RUBBER GLOVES
Supplemental Safety and Health

Chemical Properties

Boiling Pt:B.P. Text:>200F
Vapor Pres:<5
Spec Gravity:1.08
Evaporation Rate & Reference:(BU AC=1): <1
Solubility in Water:SLIGHT
Appearance and Odor:OPAQUE RED W/MILD ODOR
Percent Volatiles by Volume:<10

Stability

Stability Indicator/Materials to Avoid:YES
THERMOPLASTICS
Stability Condition to Avoid:EXCESSIVE HEAT
Hazardous Decomposition Products:OXIDES OF CARBON, ACRID SMOKE

Disposal

Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.